Xerox WorkCentre 3215NI - Using the Output Tray; Using the Rear Cover

Media Output Locations
Xerox® WorkCentre® 3215/3225
User Guide
124
Using the Output Tray
The output tray collects printed paper face down, in the order in which the sheets were printed. The
output tray should be used for most jobs. When the output tray is full, a message displays on the
control panel.
To use the output tray, make sure that the rear cover is closed.
Notes:
• If paper coming out of the output tray has problems, such as excessive curl, try printing
to the rear cover.
• To reduce paper jams, do not open or close the rear cover while the printer is printing.
Using the Rear Cover
When using the rear cover, paper comes out of the machine
face up. Printing from the bypass tray to the rear cover
provides a straight paper path and might improve the output
quality when printing on envelopes or special media.
Whenever the rear cover is open, the output is delivered there.
Note: The rear cover output can only be used for simplex
jobs. Duplex printing with the rear cover open causes
paper jams.
CAUTION: The fuser area inside the rear cover of your
machine becomes very hot when in use. Take care when
you access this area.