General Care
Xerox® WorkCentre® 3215/3225
User Guide
208
5. Hold the cartridge by the handle. Slowly insert the
cartridge into the opening in the machine. Tabs on the
sides of the cartridge and corresponding grooves within
the machine will guide the cartridge into the correct
position until it locks into place.
6. Close the front cover. Make sure that the door is securely
closed. When the green machine status light is solid, the
machine is ready.
Replacing the Drum Cartridge
1. Open the front cover.
2. Pull the toner cartridge out and place it on a clean flat
surface.
3. Pull the drum cartridge out slowly.
4. Remove the new drum cartridge from the packaging.
Follow directions on the packaging to remove the tape
and appropriate packaging pieces from the new
cartridge. Use the handle on the cartridge to avoid
touching sensitive parts that can be easily damaged.
CAUTIONS:
• To prevent damage to the drum cartridge, do not
expose it to light for more than a few minutes. Cover
it with a piece of paper, if necessary.
• Do not touch the green surface on the underside of the cartridge. Use the handle on the
cartridge to avoid touching this area.
To Next Page
Loading...
