Installation and Setup
32 Xerox
®
WorkCentre
®
3655/3655i Multifunction Printer
User Guide
Installation and Setup Overview
Before printing, your computer and the printer must be plugged in, turned on, and connected. Configure
the initial settings of the printer, then install the driver software and utilities on your computer.
You can connect to your printer directly from your computer using USB, or connect over a network using
an Ethernet cable or wireless connection. Hardware and cabling requirements vary for the different
connection methods. Routers, network hubs, network switches, modems, Ethernet cables, and USB cables
are not included with your printer and must be purchased separately. Xerox recommends an Ethernet
connection because it is typically faster than a USB connection, and it provides access to Xerox
®
CentreWare
®
Internet Services.
Note: If the Software and Documentation disc is not available, you can download the latest drivers
from www.xerox.com/office/WC3655drivers.
See also:
Selecting a Location for the Printer on page 33
Choosing a Connection Method on page 34
Connecting the Printer on page 34
Configuring Network Settings
Installing the Software on page 43
To Next Page
Loading...
