5-20
Disassembly and Reassembly
Service Manual
July 2003 WorkCentre PE16
5.17 Feed Ass'y
1. Before you remove the Feed Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Scanner Ass’y (see page 5-5)
- Front Cover (see page 5-4)
- Middle Cover (see page 5-11)
- Drive Ass’y (see page 5-18)
2. Remove the two screws securing the Guide Paper
and remove it.
3. Pull up the Feed Idle Bushing and Feed Idle Shaft, as
shown below.
4. Remove the three screws securing the Feed Bracket
and remove it.
5. Remove the Idle Gear and Feed Gear2.
To Next Page
Loading...
