37
Toner Cartridge Replacement
The Toner Indicator on the Copier Diagram will light when the toner supply
is low. Copies can continue to be made, but you should have a
replacement cartridge in stock. Copies may gradually become lighter until
the copier stops and the indicator begins to blink. In many cases, there is
not a noticeable difference between the first copy and the last copy from a
toner cartridge. The copier, however, may take longer than usual to start
copying. When this occurs the toner cartridge must be replaced. The
copier will not operate until the toner cartridge is replaced.
1. Press the release lever to open the copier.
1. Press down on the green lever (1) on the
front of the old toner cartridge and pull the
cartridge out (2).
Note: Help the environment by recycling
your used toner cartridge. Refer to the Xerox
Green Team brochure packed with the Toner
Cartridge for instructions on returning the
used Toner Cartridge to Xerox.
3. Shake the new toner cartridge horizontally
four or five times and then remove the
cover.
4. Save the box and the cover for shipping.
1. Slide the new toner cartridge in until it
locks in place.
2. Close the copier by gently pushing down
the upper half.
• Wait approximately two seconds for the
ready indicator to light.
1
2
To Next Page
Loading...
Need help?
General