34
3. Configure Transmit rates. While XetaWave radios support Multi-speed Multi-
point, for an initial configuration, it is best to start with a single speed to simplify
trouble shooting. The ideal setting is a function of distance, throughput
required, transmit power, and radio noise in the area.
RF Protocol Settings for an Ethernet network:
4. For an Ethernet network, set the initial “Max Payload Size” for both the
“Master” and “Slave” settings to 256. These settings can be modified later
based on your traffic requirements. Set “Dynamic” payloads to “ON” for an
MAS network. All radios in the network have to have the same setting. Confirm
that the “Beacon Rate” is set to 1, that the “MMS” setting is None, “MMS Hop
Offset” is set to 0, and the “Master Repeat setting” is set to 3.
To Next Page
Loading...