xFusion Digital Technologies FusionServer 2288H V7

To Next Page

To Previous Page

Port Type

Quantity

Note

Description

USB port USB 3.0 2 Used to connect to a USB 3.0

device.

NOTICE

● Before connecting an external

USB device, ensure that the

USB device functions properly;

otherwise, it may adversely

impact the server.

● The USB 3.0 port can be used

to supply power to low-power

peripherals. However, the USB

3.0 port must comply with the

USB specifications. To run

advanced peripherals, such as

external CD/DVD drives, an

external power supply is

required.

Note: The number of ports varies depending on server configuration. This table

lists the maximum number of ports in different configurations.

5.2 Rear Panel

5.2.1 Appearance

● Server with a drive module or PCIe riser module on the rear panel

Figure 5-16 Rear view

I/O module 1 2 I/O module 2

3 I/O module 3 4 PSU 2

5 PSU 1 6 (Optional) FlexIO card 2

NOTE

The FlexIO card slots

support only OCP 3.0 NICs.

FusionServer 2288H V7 Server

Technical White Paper 5 Hardware Description

xFusion Digital Technologies FusionServer 2288H V7 - 5.2 Rear Panel