xFusion Digital Technologies FusionServer 2288H V7 - Page 53

Configuratio
n
Front Drive Rear Drive Built-in Drive Drive
Management
Mode
● a: I/O module 1 (2 x 2.5") is configured with rear 2 x 2.5" drives and a PCIe riser
module.
● b: NVMe drives are supported when CPU 2 is configured. A single-CPU server
does not support NVMe drives.
● For details about the optional components, consult the local sales
representative or see "OS and Parts Compatibility" in the Compatibility
Checker.
Drive Numbering
NO TICE
The drive numbers identified by the RAID controller card vary depending on the
cabling of the RAID controller card. This section uses the drive numbers identified by
a RAID controller card that adopts the default cabling described in "Internal Cabling"
in the FusionServer 2288H V7 Server Maintenance and Service Guide.
● Drive numbering of the 12 x 3.5" drive pass-through configuration 1 in Table
5-17
Figure 5-35 Drive numbering (I/O module 1 configured with 2.5" drives)
Figure 5-36 Drive numbering (I/O module 1 configured with 3.5" drives)
FusionServer 2288H V7 Server
Technical White Paper 5 Hardware Description
Issue 02 (2023-05-25) Copyright © xFusion Digital Technologies Co., Ltd. 46