11 12
Care & Maintenance
Maintenance Precautions
Always use genuine parts to keep your warranty from being voided.
If the filter, extension rod, or high torque brush bar becomes clogged, the
vacuum cleaner will stop working shortly. To restore its functionality, clean
the clogged component.
If the vacuum cleaner will not be used for an extended period, fully charge
it and disconnect it from the power then store it in a cool, low-humidity
environment away from direct sunlight. To avoid over-discharging the battery,
recharge the vacuum cleaner at least once every three months.
Wipe the vacuum cleaner with a soft, dry cloth.
Cleaning the Vacuum Cleaner
Cleaning the Dust Compartment, Pre-filter, and Cyclone
Assembly
1. The vacuum cleaner's cleaning ability will be reduced if the dust
compartment is filled to the "MAX" mark. To regain performance, empty the
dust compartment in a timely manner. Before emptying the compartment,
make sure the vacuum cleaner is disconnected from the power, and do not
press its power button.
ONOFF
Using the Mopping Function
1. Dampen the mop pad and wring out excess water, then attach it securely to
the bottom of the water tank.
2. Open the water tank plug, add an appropriate amount of clean water, then
close the plug.
Notes:
Do not step on the water tank, as this could permanently damage it.
Heavily soiled floors should be vacuumed prior to mopping for a better result.
Do not use the mopping function on carpet.
Do not use any cleaning agents or disinfectants.
3. Attach the high torque brush bar to the water tank by lining up the magnets
on them until they snap together.
Notes:
The ball valve in the water tank controls how much water is dispensed. The ball
is a moving part and may make a rolling sound when starting and stopping.
This is normal.
When not in use, please keep the switch to the OFF position.
4. This function is designed for vacuuming and wiping down hardwood and tile
floors.
To Next Page
Loading...
