Xilinx VC707 - Chapter 1: VC707 Evaluation Board Features; Overview; Additional Information; VC707 Board Features

VC707 Evaluation Board www.xilinx.com 7
UG885 (v1.4) May 12, 2014
Chapter 1
VC707 Evaluation Board Features
Overview
The VC707 evaluation board for the Virtex®-7 FPGA provides a hardware environment for
developing and evaluating designs targeting the Virtex-7 XC7VX485T-2FFG1761C FPGA.
The VC707 board provides features common to many embedded processing systems,
including a DDR3 SODIMM memory, an 8-lane PCI Express® interface, a tri-mode
Ethernet PHY, general purpose I/O, and two UART interfaces. Other features can be
added by using mezzanine cards attached to either of two VITA-57 FPGA mezzanine
connectors (FMC) provided on the board. Two high pin count (HPC) FMCs are provided.
See VC707 Board Features for a complete list of features. The details for each feature are
described in Feature Descriptions, page 10.
Additional Information
See Appendix F, Additional Resources for references to documents, files and resources
relevant to the VC707 board.
VC707 Board Features
• Virtex-7 XC7VX485T-2FFG1761C FPGA
• 1 GB DDR3 memory SODIMM
• 128 MB Linear byte peripheral interface (BPI) Flash memory
• USB 2.0 ULPI Transceiver
• Secure Digital (SD) connector
• USB JTAG through Digilent module
•Clock Generation
• Fixed 200 MHz LVDS oscillator (differential)
•I
2
C programmable LVDS oscillator (differential)
• SMA connectors (differential)
• SMA connectors for GTX transceiver clocking
•GTX transceivers
• FMC1 HPC connector (eight GTX transceivers)
• FMC2 HPC connector (eight GTX transceiver)
• SMA connectors (one pair each for TX, RX, and REFCLK)
• PCI Express (eight lanes)
• Small form-factor pluggable plus (SFP+) connector
Send Feedback