ZCU104 Board User Guide 8
UG1267 (v1.1) October 9, 2018 www.xilinx.com
Chapter 1: Introduction
•PS MIO: CAN
• PS MIO: I2C shared across PS and PL
• PS MIO: SD
• PS MIO: DisplayPort
• PS MIO: Ethernet
•PS MIO: USB3
• PS-side user LED (one)
• PL-side user LEDs (four)
• PL-side user DIP switch (4-position)
• PL-side user pushbuttons (four)
• PL-side CPU reset pushbutton
•PL-side PMOD headers
• PL-side bank 0 PROG_B pushbutton
• Security - PSBATT button battery backup
• Operational switches (power on/off, PROG_B, boot mode DIP switch)
• Operational status LEDs (power status, INIT, DONE, PG, DDR power good)
• Power management
The ZCU104 provides a rapid prototyping platform for the embedded vision low cost (EVLC)
market using the XCZU7EV-2FFVC1156 device. The ZU7EV contains PS hard block
peripherals exposed through the multi-use I/O (MIO) interface and several FPGA
programmable logic (PL), high-density (HD), and high-performance (HP) banks. Table 1-1
lists the resources available within the ZU7EV. See the Zynq UltraScale+ MPSoC Data Sheet:
Overview (DS891) [Ref 1] for a feature set overview, description, and ordering information.
To Next Page
