When the
motor code is
read
automatically,
the motor
parameter is 0
On the premise that the driver and
motor are matched and can be used
together, read the alarm shielding
position of motor parameters through
P0-53, and set the motor code
correctly
The auto read motor
code is inconsistent
with the motor code
set in P0-33
Check U3-00 and motor label.
① If the two values are the same,
change P0-33 motor code or set P0-33
to 0 to read motor code automatically;
② If the two values are different,
contact the manufacturer for technical
support
Interruption of
data
interaction
with
CANopen
master station
Communication
interruption between
master and slave
station
①Check whether the CAN network
wiring is disconnected or damaged;
② Check whether the CANopen master
station is powered down;
③ After ensuring that there is no
problem with the wiring, first power off
and restart CANopen slave station, and
then power off and restart CANopen
master station.
To Next Page
Loading...
Need help?
General
