For the stop sequencer function (SHIFT+STOP) a security function is available which forces you to
press STOP a second time while holding the SHIFT button. In that case a notification will appear
on the screen and you can avoid the sequencer stop if the buttons were pressed unintended.
This feature can be enabled/disabled in the → Setup Screen
SHIFT - Get to the 2
nd
function of buttons or edit functionality
OK – Create a new pattern / patch / table, Enter pattern/patch/table (depends on setting).
Enter/Accept, Pre-listen Note, Clone patterns, patches and tables in combination with the SHIFT
button
UP – Page up for 16 steps → move the cursor 16 rows up
DOWN – Page down for 16 steps → move the cursor 16 rows down
Lastly, the cursor keys are on the right.
Note that there are also some other combinations of the keys in different screens which will be
explained later on.
For simple navigation you use the cursor keys:
Cursor up/down/left/right for simple navigation and scrolling
In most screens you can move your cursor and navigate like this. For example, in the sequencer
screen you change the Row by using cursor up/down and change the Track/Column by using
cursor left/right.
Using the cursor keys combined with the Shift key allows mostly some editing, as here explained
for the pattern screen:
SHIFT + CURSOR LEFT -> Decrease (-) value by 1 (value or semitone for notes)
SHIFT + CURSOR RIGHT -> Increase (+) value by 1 (value or semitone for notes)
SHIFT + DOWN/UP -> Decrease/Increase value by:
• 1 octave for notes
• 16 ($10) for regular values which can be < FF (255)
64 ($40) for values which can be > FF (255)
• 10 for FX types
• Depending on the types, other values are possible
So changing values is always in the smallest step by using SHIFT+CURSOR LEFT/RIGHT and in
bigger steps by using SHIFT+CURSOR UP/DOWN
Additionally, if the Editsteps are enabled (Setup Screen):
NerdSEQ – a tracker based Eurorack sequencer Page 14
User Manual Revision V1.26 for Firmware V1.26 12 July 2022
To Next Page
Loading...