Xprinter R330H - 5.7 Paper Cutting Problems

22
5.7 Paper Cutting
Fault
Possible cause
Solution
Knife is jammed
The blade is distorted
Change the cutter
The motor is burned
Change the cutter
Scraps of paper are accumulated
Clean the scraps on transmission parts
Paper is jammed
Plate of driving head is over-heated
Lower heating power of the driving head
Paper feed position is not correct
Align edge of paper with the paper slot and put
the paper between the rubber roller and TPH
Paper is not cut off
Blade is damaged or worn
Change the cutter
Paper is too thick
Change standard paper