1-1
Chapter 1 – Introduction
Product Overview
The 9460/9462 and 9460KP/9462KP Flat-Panel Industrial Computers combine a
PC/AT™ computer with a flat-panel display to offer a powerful, compact package for the
factory floor and other harsh environments. The 9460/9462 and keypad version features
an open architecture to meet a wide variety of applications that require both a powerful
PC and a durable industrial enclosure. The system integrates a computer card cage, mass
storage, display, and power supply in a truly industrial form factor.
The front panels of the units are sealed to NEMA 4/4X/12 and IP65 (9460/9462 only),
standards and is protected by an impact-resistant shield. The 9460KP and 9462KP ver-
sions are sealed to NEMA 4/4X/12.
The processor board combines all the functions of a complete IBM PC/AT compatible
computer on a single industrially hardened circuit board. Refer to the Xycom CPU manual
for more information on processor and hardware features.
The system’s modular design allows easy access to expansion boards, switches, power
supply, flat-panel display, and disk drives.
Standard Features
The 9460/9462 and the keypad versions offer the following standard features:
• AHIP4+ board high performance 133 MHz, AMD
Am5x86 CPU
• 72-pin EDO DRAM SIMM supports (4,8,16, 32, and 64 Mbytes)
• 32-pin CMOS RAM site
• PCI 64 bit video controller, 1 Mbyte video RAM
• PCI local-bus IDE controller
• Two serial COM ports with one as RS-232 and one configurable as RS-232, or
RS-485
• Parallel port
• VGA port
• Flash BIOS
• 5.75-inch mounting depth (6.5-inch with external floppy option)
• External floppy connector
• Flat-panel display
• 10.4-inch TFT or STN passive color(640x480) (9460)
• 12.1-inch TFT or STN passive color (800x600) (9462)
To Next Page
Loading...