en - Original instructions
14 Genyo plus, Additional Installation, Operation and Maintenance Instructions
4 Installation
4.1 Precautions
Before starting, make sure that the safety instructions shown in Introduction and Safety on
page 4 have been fully read and understood.
DANGER:
All the hydraulic and electrical connections must be completed by a technician possessing the
technical
-professional requirements outlined in the current regulations.
DANGER: Potentially explosive atmosphere hazard
It is prohibited to start the unit in environments with potentially explosive atmospheres or with
combustible dusts.
WARNING:
Always wear personal protective equipment.
WARNING:
Always use suitable working tools.
cting the place of installation and connecting the unit to the hydraulic and electric
power supplies, strictly comply with current regulations.
4.2 Installation area
• Follow the provisions in Technical Information on page 31
• Install the unit in a dry and well ventilated area
• Place the unit in a raised position in relation to the floor
• Make sure that any leaks will not cause flooding to the installation area or submerge the
unit
• In case of installation of the unit outdoors, ensure appropriate protection against snow, rain
and direct sunlight.
4.3 Hydraulic connection
WARNING:
Piping must be sized to ensure safety at the maximum operating pressure.
WARNING:
Install appropriate seals between the connections o
f the unit and the piping.