Xylem Lowara Genyo plus - Pressure Setting Procedures; Setting Start and Stop Pressure Values

en - Original instructions
Genyo plus, Additional Installation, Operation and Maintenance Instructions 21
4
Confirm
5.2.4 Setting the P START and P STOP pressure values
Set the P START and P STOP pressure values upon initial start-up or after modifying the
conditions of installation.
The calibrated P START and P STOP pressure values are shown in the diagram.
Note:
P START – P STOP ≥ 0.1 MPa / 1 bar (14.5 psi).
Setting the P START
Phase
Action
Illustration
1
With the unit in OFF or
AUT mode, press several
times to view the pressure
(bar or psi)
2
Press once: the display
flashes and shows the P
START value
Genyop_M0018_A_th
H
P STOP
P START
Q
Pmax