en - Original instructions
28 Genyo plus, Additional Installation, Operation and Maintenance Instructions
7 Maintenance
7.1 Precautions
Before starting, make sure that the instructions shown in Introduction and Safety on page 4
have been fully read and understood.
enance must be done by a technician possessing the technical-
professional requirements
outlined in the current regulations.
WARNING:
Always wear personal protective equipment.
WARNING:
Always use suitable working tools.
liquids that are excessively hot or cold, pay attention to the risk of injury.
DANGER: Electrical hazard
Before starting work, check that the unit is unplugged and that the
pump unit, the control
panel and the auxiliary control circuit cannot restart,
even unintentionally.
7.2 Maintenance every 3 months of operation
1. Check the integrity of the power supply cord; if the cable is damaged contact Xylem or the
Authorised Distributor for its replacement.
2. Carefully clean the unit.
7.3 Spare parts ordering
Identify the spare parts with the product codes directly on the site www.lowara.com/spark.
Contact Xylem or the Authorised Distributor for technical information.
To Next Page
Loading...