Xylem WTW OxiTop-IDS - 3 Commissioning

Commissioning Multi 3630/3620 IDS
8 ba77045e01 09/2019
3 Commissioning
To carry out BOD measurements with the Multi 3630/3620 IDS meter, proceed
as follows:
 If necessary, disconnect any other sensors from the meter (simultaneous
operation with IDS sensors is not possible)
 Plug the WLM-M adapter to the Multi 3630/3620 IDS meter
(see operating manual of the WLM system)
 Switch on the Multi 3630/3620 IDS meter
(see operating manual of the Multi 3630/3620 IDS meter)
 For initial commissioning, press
<M_> to switch the meter to operation with
OxiTop
®
-IDS measuring heads.
 Switch on the OxiTop
®
-IDS measuring heads
(see operating manual OxiTop
®
-IDS of the measuring head)
 Assign an extra ID to each OxiTop
®
-IDS measuring head
(see operating manual OxiTop
®
-IDS of the measuring head)
Information on how to put the Multi 3630/3620 IDS into operation is
given in the operating manual of your meter.
Information on how to put the WLM-M adapter into operation is
given in the operating manual of the WLM system.