FT-252 OperaTing Manual 57
Set Mode Item 16
[
DT SPD
]
Function: Setting of the DTMF Autodialer Sending Speed.
Available Values: 50MS (high speed)/100MS (low speed)
Default: 50MS
Set Mode Item 17
[
DT WRT
]
Function: Programming of the DTMF Autodialer.
See page 43 for details.
Set Mode Item 18
[
EDG.BEP
]
Function: Enables/Disables the Band-edge beeper while selecting the frequency via the
DIAL
knob.
Available Values: BEP.OFF/ BEP. ON
Default: BEP.OFF
Set Mode Item 19
[
EMG S
]
Function: Selects the alarm(s) utilized when the Emergency function is engaged.
Available Values: EMG.BEP/EMG.LMP/EMG.B+L/EMG.CWT/EMG.C+B/EMG.
C+L/EMG.ALL/OFF
Default: EMG.B+L
EMG.BEP: Loud “Alarm” sounds.
EMG.LMP: The LCDs lamp ashes.
EMG.B+L: Loud “Alarm” sounds and the LCD/Keypad lamp ashes.
EMG.CWT: Transmits the Morse Code “SOS” (• • •
– – –
• • •) message on the air be-
ginning one minute after activation of the Emergency function.
EMG.C+B: Loud “Alarm” sounds and the Morse Code “SOS” (• • •
– – –
• • •) mes-
sage is transmitted on the air beginning one minute after activation of the
Emergency function.
EMG.C+L: The LCD lamp ashes, and the Morse Code “SOS” (• • •
– – –
• • •) mes-
sage is transmitted on the air beginning one minute after activation of the
Emergency function.
EMG.ALL: All of the above are activated.
OFF:
Disables the Emergency function.
When the radio is set to the EMG.CWT, EMG.C+B, EMG.C+L, or EMG.ALL mode,
the radio will be instructed to send “DE (your callsign)” after the sending of the SOS
message, if your callsign is entered via Set Mode Item 11:
CWID
.
Set Mode Item 20
[
F STEP
]
Function: Setting of the synthesizer steps.
Available Values: 5/10/12.5/15/20/25/50/100 kHz, or AUTO
Default: AUTO (Step automatically changes according to operating frequency.)
Set
(
Menu
)
Mode
honbun_130313.indd 57 2013/03/13 19:48:12
To Next Page
Loading...
