FT-252 OperaTing Manual58
Set Mode Item 21
[
LAMP
]
Function: Selects the LCD/Keypad Lamp mode.
Available Values: KEY/CONT/OFF
Default: KEY
KEY: Illuminates the Keypad/LCD lamp for ve seconds when you rotate the
DIAL
knob or press the keypad or any switch (except
PTT
switch). This is the facto-
ry-programmed default setting.
CONT: Illuminates the Keypad/LCD lamp continuously.
OFF: Disables the Keypad/LCD lamp.
Set Mode Item 22
[
LOCK
]
Function: Selects the Control Locking lockout combination.
Available Values: LK KEY/LKDIAL/LK K+D/LK PTT/LK P+K/LK P+D/LK ALL
Default: LK K+D
Note: “K” = “Key;” “D” = “Dial;” and “P” = “PTT.”
Set Mode Item 23
[
M/TCAL
]
Function: Selects the
[
VOL/SQL
]
key function.
Available Values: MONI/T-CALL
Default: Depends on the transceiver version.
MONI: Pressing the
[
VOL/SQL
]
key causes the Noise/Tone Squelch to be over-
ridden, allowing you to listen for weak (or non-encoded) signals.
T-CALL: Pressing the
[
VOL/SQL
]
key activates a 1750-Hz burst tone, used for repeater
access in many countries (especially in Europe).
Set Mode Item 24
[
MEM.TAG
]
Function: Stores Alpha-Numeric “Tags” for the Memory channels.
See page 24 for details.
Set Mode Item 25
[
NAME
]
Function: Toggles the display indication between “frequency” and the channel’s “Alpha/
Numeric Tag.”
Available Values: FREQ/ALPHA
Default: FREQ
Set Mode Item 26
[
PASSWD
]
Function: Enables/disables the Password feature.
Available Values: PWD.OFF/PWD. ON
Default: PWD.OFF
Set Mode Item 27
[
PSWD W
]
Function: Stores the password.
Available entries are 0-9, A, B, C, D, E, and F.
Set
(
Menu
)
Mode
honbun_130313.indd 58 2013/03/13 19:48:12
To Next Page
Loading...
