Yaesu FT-252 - Page 61

FT-252 OperaTing Manual 59
Set Mode Item 28
[
R SHIFT
]
Function: Sets the magnitude of the repeater Shift.
Available Values: 0.00 - 99.95 MHz (50 kHz increments)
Default: Depends on the operating band and transceiver version.
Set Mode Item 29
[
RESUME
]
Function: Selects the Scan Resume mode.
Available Values: BUSY/HOLD/TIME
Default: TIME
BUSY: The scanner will hold until the signal disappears, then will resume when the
carrier drops.
HOLD: The scanner will stop when a signal is received, and will not restart.
TIME: Thescannerwillholdfortheveseconds,thenresumewhetherornottheother
station is still transmitting.
Set Mode Item 30
[
REV/HM
]
Function: Selects the function of the
[
REV
(
HOME
)]
key.
Available Values:
<
REV
>
/
<
HOME
>
Default: <REV>
< REV > : Pressing the
[
REV
(
HOME
)]
key reverses the transmit and receive frequencies
during repeater operation.
< HOME > : Pressing the
[
REV
(
HOME
)]
key instantly recalls a favorite “Home” channel.
Set Mode Item 31
[
RF SQL
]
Function: Adjusts the RF Squelch threshold level.
Available Values: S-1/S-2/S-3/S-4/S-5/S-7/S-FULL/OFF
Default: OFF
Set Mode Item 32
[
RPT.MOD
]
Function: Sets the Repeater Shift Direction.
Available Values: RPT.OFF/RPT. –/RPT. +
Default: Depends on the transceiver version, as well as the setting of Set Mode Item 5:
ARS
.
Set Mode Item 33
[
PRI.RVT
]
Function: Enables/disables the Priority Revert feature.
Available Values: RVT.OFF/RVT. ON
Default: RVT.OFF
See page 36 for details.
Set Mode Item 34
[
RXSAVE
]
Function: Selects the Receive-mode Battery Saver interval (“sleep” ratio)
Available Values: 200 MS(1:1)/300 MS(1:1.5)/500 MS(1:2.5)/1 S(1:5)/2 S(1:10)/OFF
Default: 200 MS
Set
(
Menu
)
Mode
honbun_130314.indd 59 2013/03/14 17:46:52