P/N YRD256-MNL-0003 Rev F
21
Tab
Hardware Troubleshooting
Helpful Tip:
Ensuring smooth deadbolt operation can enhance your battery life.
If deadbolt does not fully extend, consider increasing
depth of deadbolt strike pocket in frame.
For help with misalignments, watch our door
alignment video:
https://www.yalehome.com/en/yale/yalehome/support/
yrl-electronic-lock-faqs/electronic-lock-installation/
3. Reinstall strike plate using a manual screw driver
and test again.
If you feel resistance, ensure deadbolt strike plate
aligns with deadbolt. If deadbolt strike plate is out of
alignment, please attempt to adjust
knob/lever/handleset strike using steps below. The
knob/lever/handleset latch engagement into the strike is
the main component used for door alignment.
To adjust Knob/Lever/Handleset strike plate:
1. Remove plate from door frame with a manual
screwdriver. (Using an electric driver may strip screw
heads or enlarge screw holes.)
2. Locate strike plate tab.
Bend the tab towards surface of
strike. Note: a small change may be
all that is required
4. If door cannot be adjusted sufficiently with strike
tab, both knob/lever/handleset latch and deadbolt
latch could require adjustment – we suggest you
contact a local locksmith for assistance.
Thumbturn
Door Open
Keypad
Door Open
Thumbturn
Door Closed
Test with door
closed using
thumbturn.
If deadbolt does not extend or retract easily when testing thumbturn and keypad operation,
revisit inside and keypad installation steps. It is important that the bolt be in the retracted
position during lock installations and that installation procedure is followed carefully.
To Next Page
Loading...
Need help?
General
