Table 1. Instrument and Controls (See Figure 3, Figure 4, Figure 5, Figure 6, and Figure 7) (Continued)
Item No. Item Function
6 (cont) Battery Indicator/Hour-
meter
Diagnostics and Fault
Codes
NOTE: The dash indi-
cator will display the
code: EP 107 (or a
higher number) for 1 to 2 seconds every time
the key switch is turned to the ON position. This
code represents the EEPROM software version
and DOES NOT INDICATE A FAULT CODE.
NOTE: Fault codes may be generated in response to extreme operating conditions
such as rapid stops, potholes, or a severely discharged battery, therefore disabling
the truck. Most fault codes may be reset by turning the key switch to the OFF posi-
tion, then returning to the ON position. If the fault code will not reset, report the fault
immediately.
A fault indicator is also included. The red LED "wrench" symbol and "AL" are dis-
played if fault occurs.
For information about the diagnostics and fault codes, reference the Service Man-
ual.
Model Description
32
To Next Page
Loading...
