44 Chapter 5—Building Configurations
DME32—Owner’s Manual
How to Build & Edit Configurations
The following procedure outlines how to build and edit configurations.
1 Select Edit mode.
See “Selecting Edit Mode” on page 45.
2 Open a new or saved configuration.
See “Opening New Configuration Windows” on page 45 or “Opening Saved Configu-
rations” on page 46. A new configuration window is opened when DME Manager
starts.
3 Add components as necessary.
See “Adding Components” on page 47.
Use the Align and Zoom functions for assistance. See “Aligning Components to the
Grid” on page 49 and “Zooming Configuration Windows” on page 50.
4 Edit components as necessary.
See “Editing Components” on page 48.
5 Wire the components together.
See “Adding Wires” on page 51 and “Deleting Wires” on page 56.
6 Compile the configuration.
See “Compiling Configurations” on page 61.
7 Save the configuration.
See “Saving Configurations” on page 60.
8 Transfer the configuration to the DME32.
See “Sending Configurations to the DME32” on page 62.
9 Take the system for a run, creating scenes as necessary.
See “Running the System” on page 65.
To Next Page
