Yamaha RX-V6ABL - How to connect speakers

How to connect speakers
Connecting the speaker
Connect a speaker cable between the negative (–) terminal of the unit and the negative (–) terminal of the
speaker, and between the positive (+) terminal of the unit and the positive (+) unit of the speaker.
Remove the unit’s power cable from an AC wall outlet before connecting the speaker.
F
RONT
SPEAKERS
aa
b
d
c
+ (red)
- (black)
NOTICE
(
Prepare speaker cables in a place away from the unit, to avoid accidentally dropping wire strands into the unit's interior which
could result in a short circuit or malfunction of the unit.
(
Improper connecting of the speaker cables may cause a short circuit and also damage the unit or the speakers.
(
Do not let the bare wires of the speaker cable touch one another.
(
Do not let the bare wires of the speaker cable come into contact with the unit’s metal parts (rear panel and screws).
1 Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker
cable, and twist the bare wires of the cable firmly together.
2 Loosen the speaker terminal.
3 Insert the bare wires of the cable into the gap on the side of the terminal.
4 Tighten the terminal.
This completes the connection.
65
PREPARATIONS > Connecting speakers