EasyManua.ls Logo

Yamaha Sniper - Checkingthecoolingsystem

Yamaha Sniper
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
2
3
4
5
CHK
ADJ
3-24
CHECKINGTHECOOLANTLEVEL/
CHECKINGTHECOOLINGSYSTEM
cC
99
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentration
of the coolant.
99
Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Check:
9
coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until it settles.
EAS00104
CHECKING THE COOLING SYSTEM
1. Remove:
9
side cowlings (left and right)
9
front cowling
Refer to “REMOVING THE SIDE COWL-
INGS” and “REMOVING THE FRONT
COWLING”.
2. Check:
9
radiator
1
9
water pump inlet hose
2
9
radiator outlet hose
3
9
radiator inlet hose
4
9
thermostat outlet hose
5
Cracks/damage
→
Replace.
Refer to “COOLING SYSTEM” in chapter 5.
3. Install:
9
front cowling
9
side cowlings (left and right)
Refer to “REMOVING THE FRONTCOWL-
ING” and “REMOVING THE SIDE COWL-
INGS”.
http://www.motorcycle.in.th

Table of Contents