14 En
Connect the antenna if you want to listen to the FM (☞ P. 3).
Display information
If you press DISPLAY on the remote control, the information shown on the front panel display will be switched in the
following order.
Displaying Radio Data System information (U.K. model only)
If you press DISPLAY on the remote control while Radio Data System information is
being received, the information shown on the front panel display will be switched in the
order shown at right.
If the signal transmission of the Radio Data System station is too weak, this unit may not be able to
receive Radio Data System information completely. In particular, RT (Radio Text) information uses a
lot of bandwidth, so it may be less available compared to other types of information.
LISTENING TO FM STATIONS
Selecting an FM station
1 Press the RADIO source button repeatedly
to switch the audio source to FM.
2 Tuning FM stations.
Automatic tuning: Press and hold
TUNING /
.
Manual tuning: Press TUNING / repeatedly.
If you tune to a station manually while receiving FM, the
sound will be monaural.
Preset number and frequency Reception status*
* Examples of reception status indication.
TUNED/STEREO: A strong FM stereo broadcast is being received.
TUNED/MONO: Receiving an FM broadcast in monaural (even if the FM broadcast is stereo, reception will be
monaural if the signal is weak).
Not TUNED: No broadcast is being received.
PS (Program Service)
PTY (Program Type)
RT (Radio Text)
CT (Clock Time)
Reception status
Preset number and
frequency
To Next Page
Loading...
Need help?
General
Weight and Dimensions
