Yamaha VIKING 2021 - Wheel Installation; Battery

9-42
9
EBU33031
Wheel installation
1. Install the wheel and the nuts.
TIP
For BHF9: be sure to install the nuts with their
tapered side towards the wheel.
BHF9
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
WARNING
EWB03400
Do not reverse the rims on your Yamaha
Viking to widen the track width. Installing
wheels improperly increases the risk of
wheel failure and accidents.
EBU32643
Battery
This model is equipped with a 12–volt VRLA
(valve–regulated lead–acid) battery. There is
no need to check the electrolyte or to add dis-
tilled water. However, the battery lead con-
nections need to be checked and tightened,
and the battery terminals cleaned if corroded.
If the battery seems to have discharged, re-
charge it as soon as possible.
1. Tapered nut
1
Tightening torques:
Front wheel nut:
75 N·m (7.5 kgf·m, 55 lb·ft)
Rear wheel nut:
75 N·m (7.5 kgf·m, 55 lb·ft)
UBHF11E0.book Page 42 Friday, October 1, 2021 5:00 PM