Yamaha VIKING 2021 - Vehicle Operation Controls & Features

5-11
5
EBU31391
Light switch “ / / ”
Set the switch to “ ” to turn on the low
beam and the taillights.
Set the switch to “ ” to turn on the high
beam and the taillights.
Set the switch to “ ” to turn off the head-
lights and taillights.
NOTICE
ECB02061
Do not use the headlights with the engine
turned off for an extended period of time.
The battery may discharge to the point
that the electric starter will not have
enough power to crank the engine. If this
should happen, remove the battery and re-
charge it.
EBU39121
On–Command drive knob
“2WD/4WD/DIFF. LOCK”
Stop the vehicle and move the On–Command
drive knob to change the drive mode to two–
wheel drive, four–wheel drive, or four–wheel
1. Light switch “ / / ”
L
H
1
L
H
L
H
1. On-Command drive knob “2WD/4WD/DIFF. LOCK”
1
UBHF11E0.book Page 11 Friday, October 1, 2021 5:00 PM