9-47
9
vehicle and the other end of the positive
lead to the positive terminal of the
charged battery.
4. Connect the negative lead of the jumper
cable to the negative terminal of the
charged battery and the other end of the
negative lead to an unpainted metal sur-
face of the frame of the vehicle to be
started.
5. Start the engine. (See page 7-2.)
6. After the engine starts, disconnect the
negative lead of the jumper cable from
the frame and charged battery, and then
disconnect the positive lead of the jump-
er cable from the charged battery and the
battery in the vehicle.
7. Install the hood.
1. Jumper cable positive lead
1. Jumper cable negative lead
UBHF11E0.book Page 47 Friday, October 1, 2021 5:00 PM
To Next Page
Loading...
