9-53
9
2. Remove the brake/tail light bulb holder
(together with the bulb) by turning it
counterclockwise.
3. Push the burnt-out bulb in and turn it
counterclockwise to remove it from the
bulb holder.
4. Push a new bulb in and turn it clockwise
to install in the bulb holder.
5. Install the bulb holder (together with the
bulb) by turning it clockwise.
6. Install the panel.
1. Panel B
1. Quick fastener screw
2. Panel front bolt and panel nut
3. Panel rear bolt
4. Panel A
1. Brake/tail light bulb holder
UBHF11E0.book Page 53 Friday, October 1, 2021 5:00 PM
To Next Page
Loading...
