Yamaha WaveRunner VX 700 Service Manual

3-10
1
2
3
4
5
6
7
8
9
A
TIP:
Remove the bilge strainer case 1 by pushing
the hooks on the bilge strainer inward.
3. Install the bilge strainer case 1.
Drain plug check
1. Check the O-ring of each drain plug.
Replace if cracked or damaged. See
“Drain plug check” (8-29).
Lubrication points
Throttle cable and choke cable lubrication
1. Lubricate the throttle cable (handlebar
end).
TIP:
Before lubricating the throttle cable, squeeze
the throttle lever, and then remove the rubber
seal 1.
2. Lubricate the throttle cable (carburetor
end).
3. Lubricate the choke cable (carburetor
end).
Nozzle pivot shaft and steering cable
lubrication
1. Lubricate the nozzle pivot shaft and
steering cable.
Steering cable and steering cable joint
lubrication
1. Lubricate the steering cable and steering
cable joint.
Recommended lubricant: Rust inhibitor
Recommended lubricant:
Yamaha grease A
Recommended lubricant:
Yamaha grease A
Periodic service

Yamaha WaveRunner VX 700 Specifications

General

Model	WaveRunner VX 700
Displacement	701cc
Fuel Capacity	13.2 gal
Rider Capacity	3
Width	46.1 inches