18
4) How to change the setting of Buzzer (Parameter No. 03)
e.g.) Change the setting value at Parameter No. 03 from 000 (No sound) to 003 (Beep at over
weight).
Operation Display
1
Press
to turn on the scale.
2
While pressing
, press to enter the parameter
setting mode.
3
Press
to move the parameter No. from 01 to 03.
Note) When passing by “03”, keep pressing
until looping
back to “03”.
4
Press
or to change the value to “003”.
Note)
key : move the value forward (+1)
key : move the value backward (-1)
000 No sound
001 Beep at under weight
002 Beep at over weight
003 Beep at acceptable weight
004 Beep at under & over weight
5
Press
to store the setting value. The display goes to the
next parameter.
Note) The setting value is not saved unless the display goes
to the next parameter.
6
Press
for a while to turn the power off.
7
Press
to turn the power on.
The beep setting has been ready.
To Next Page
Loading...
Need help?
General
