Yamato UDS-1V-WP - How to Change User Parameter; Change Auto-off Timer Setting

17
HOW TO CHANGE USER PARAMETER
3) How to change the setting of Auto-off Timer (Parameter No. 05)
e.g.) Change the setting value at Parameter No. 05 from 003 (15 min. after no use) to 005 (60 min.
after no use).
Operation Display
1
Press
to turn on the scale.
2
While pressing
, press to enter the parameter
setting mode.
3
Press
to move the parameter No. from 01 to 05.
Note) When passing by “05”, keep pressing
until looping
back to “05”.
4
Press
or to change the value to “005”.
Note)
key : move the value forward (+1)
key : move the value backward (-1)
5
Press
to store the setting value. The display goes to the
next parameter.
Note) The setting value is not saved unless the display goes
to the next parameter.
6
Press
for a while to turn the power off.
7
Press
to turn the power on.
The auto-off timer has been set.