12
it is indeed required by customer, the special chuck guard can be provided
but it should be confirmed that only the face chuck is used and any case
should be responsible by customer himself.
1-5 The Use of Emery Cloth in Metal Processing Can Cause Danger
In all accidents occurred on the lathe, most are from the use of emery
cloth to cause breakage of fingers, or even to amputate occasionally.
When workpieces with different shapes are rotating on the lathe, if
using emery cloth to deburr, to polish or to process finished sizes, it can
cause the accident when winding emery cloth on the workpiece to be
ground by two hands. If winding the emery cloth on the finger or to make
rough grinding, the finger could be seized firmly to cause serious injury.
Precautions
The operator should have certain recognition and knowledge on the
necessity to treat part by emery cloth on the lathe.
It is not needed to process by emery cloth in following cases:
If the requirement of the surface roughness is not so high;
Make processing by turning or on special polisher or grinding machine,
the finished sizes and surface roughness can be achieved well.
If technological rule defines that the workpiece should be ground by
Instructions Manual for CL-38 (L190)
To Next Page
Loading...