5
5. Before starting the lathe, you should understand how to stop it.
6. The lathe cannot be operated under overload.
7. Stop running of the lathe immediately in case any accident occurs.
8. When mounting the chuck or other attachment on the spindle, switch
off power supply of the lathe to prevent rotation of the spindle.
9. Do not mount the jigger if it is not checked of confirmed to be
compatible with the lathe.
10. Check the center you used if its load capacity can meet with
requirement.
11. Switch off power supply before leaving the lathe.
12. The maximum weight of the workpiece on the lathe is 500 kg.
13. The chuck should be properly and firmly mounted on the spindle of
the lathe.
14. Take care that the workpiece should be gripped firmly and the
speed of the spindle
cannot exceed the safe speed of the chuck.
15. As it is possible to contact with human body, especially when the
material with small diameter is used, it is not allowed in any case that the
rod material cannot extend out the end of the spindle of the headstock
which has no special guard and relative support.
16. There is the label of speed limit for the chuck and that no speed
change is allowed in operation at the lower right corner of the headstock,
the electric warning board at the electric cabinet (box) and that no touch
on the workpiece (or chuck) when it is rotating on the guard of the chuck
to remind you to take care.
1-2 Danger of Operation
When operating the lathe you should fully understand the danger of
following operations:
1) Cutting Fluid
The cutting fluid is hazardous to human body. To contact the cutting
Instructions Manual for CL-38 (L190)
To Next Page
Loading...