14
When the end of the workpiece is polished, only a short piece of the
emery cloth shall be used as it cannot be wound.
When polish by the emery cloth is made, never operate by wearing
gloves.
1-6 Safety devices
Operate the lathe only with properly functioning safety devices.
Stop the lathe immediately if there is a failure in the safety device or if
it is not functioning for some reason.
It is your responsibility!
If the safety device has been activated or has failed, the lathe must only
be operated again when
•
the cause of the failure has been removed,
•
you have made sure that there is no existing danger for persons or
objects.
WARNIN G!
If you bypass, remove or override a safety device in any other way,
you are endangering yourself and other persons working on the lathe.
The possible consequences are the following
•
injuries due to components or parts of components flying off at
high speed,
•
contact with rotating parts,
•
fatal electrocution,
•
pulling-in of clothes.
The lathe includes the following safety devices:
•
a lockable main switch,
•
an EMERGENCY-STOP button,
•
a protective cover on the headstock with position switch,
•
a lathe chuck protection with position switch,
•
a recoil spring as protective cover on the guide spindle, the coil
Instructions Manual for CL-38 (L190)
To Next Page
Loading...