Yanmar
®
600 Control Panel Operation and Troubleshooting
16 463-3000-09 Initial - 16-May-2008
If the two PINs entered do not match an error
message is displayed and the PIN is unchanged.
Warning
If the PIN is changed from the default and
the new PIN is lost, the configuration mode
will not be accessible.
Clearing the PIN requires returning the
display to Yanmar for service.
About
Displays the following product information:
ID/Build Serial number of the display
EEPROM Number of writes on EEPROM
PART No Unit part number
VERS Software version number
CHK Flash memory checksum
SOURCE The source of received data
LIB1 Low level system library
version
LIB2 Low level Graphical Display
Interface library version (if
used)
Note
This screen can not be exited until the
checksum calculation is complete.
Checksum calculation takes approximately 10
seconds and is complete when the checksum
value changes from Calculating… to a
hexadecimal value such as 0x704E – OK
To Next Page
Loading...