6 Maintenance by the operator
153
6.5.4 Increasing the tension
1. Prepare a grease pump.
2. Loosen the two screws and rotate the bottom cover to
access the lubrication nipple.
a = Cover
3. Raise the machine with the equipment by activating
the command lever.
4. Using the grease pump, inject grease with the greaser
so that the play H is between 105 ~ 115 mm.
5. To check that the tension is correct, put the machine down and move it gently forwards and
back.
6. Check the tension again. If it is still not correct, adjust it again.
7. Re-install the cover.
Note
The tension may be adjusted until the distance A
is reduced to 0. If the tension is insufficient after
being adjusted, the pin and the peg must be re-
placed. Contact your dealer for repair.
• If the tension is weak even after grease is injected, the track must be replaced. Contact your
dealer.
To Next Page
