X K 3 1 9 0－C 602
Table 4-5 Parameter 2 of Catchweigher
(when 【SET 1】 parameter 13A is set as 2 or 3 in table 4-3)
Para
mete
r
Indicator
display
Parameter explanation Remarks
1
[ A]
[CtrL ]
A—catchweighing mode
(0: non-peak hold, 1: peak
hold)
2
[******]
[A ]
Upper limit of channel 1:
If “zero zone” ≤X＜A, the
indicator outputs signal of
channel 1 at t3.
Refer to note of parameter 8
for meaning of X. Same for
below.
3
[******]
[b ]
Upper limit of channel 2:
If A≤X ＜ b, the indicator
outputs signal of channel 2 at
t3.
4
[******]
[C ]
Upper limit of channel 3:
If b ≤X ＜ C, the indicator
outputs signal of channel 3 at
t3.
5
[******]
[d ]
Upper limit of channel 4:
If C≤X ＜ d, the indicator
outputs signal of channel 4 at
t3.
If X ≥d, the indicator will
output signal of channel 5 at
t3.
6
[******]
[0_Zone]
Zero zone:
1. After sending
catchweighing signal, it will
not enter the next cycle until
the weight measured by
indicator is below this value;
2. Under self-control mode, it
will not enter t1 until the
weight measured by
indicator is above this value.
3. If X is below zero zone,
the indicator will not output
channel signal at t3.
To Next Page
Loading...
