X K 3 1 9 0－C 602
Display method of program step Set Parameter 17B of【SET 0】to 4. Under running status,
the auxiliary display of the instrument will show the current program step number in forms of
‘Step**’.
Table 8-4 Description of Program Step in External Control Mode
Program
Step
Description
1
If the external signal I3 is valid, go to program step 2 and the timer
will be T0.
2
Timing T0 is over. Start to calculate the average weight, go to
program step 2 and the timer will be T1.
3
Record the weight record. Timing T1 is over; calculate the average
weight during the time interval T1, go to program step 4 and the
timer will be T2.
4
Timing T2 is over. Save the weight data and sort it by the weight.
Output the batching signal by the channel and timer will be T3.
5
Timing T3 is over. Close the batching signal. If the weight is back
to zero zone, go to program step 1.
To Next Page
Loading...
