X K 3 1 9 0－C 602
7
[ ***]
[t0 ]
Judgment delay (0 ~ 25.5)
seconds:
Under external control mode,
when it is activated, data
calculation is started after
t0;
Under self-control mode, data
calculation is started after t0
when weight is out of zero
zone.
Please refer to parameter 6
for the definition of “zero
zone”.
8
[ ***]
[t1 ]
Time for calculation of
average weight
(0 ~ 25.5) seconds:
After t0, the indicator will
sum the weight values and
figure out the average
during time t1. The obtained
value serves as
catchweighing basis.
Assume that the obtained
value is X.
9
[ ***]
[t2 ]
Calculation delay (0 ~ 25.5)
seconds:
After t1 calculation is over,
the indicator remains inactive
during t2 time, waiting with
delay.
This setting can meet more
control site requirements.
10
[ ***]
[t3 ]
Time for sending signal
(0 ~ 25.5) seconds:
After t2, the indicator sends
catchweighing signal with
length of t3
Please refer to the
explanation of parameter 2
~ parameter 5.
11
[ A]
[Print?]
A—whether to print
parameter setting
(0: No: 1: Yes)
II. Calibration
Message: The calibration switch should be opened when the calibration is started,
otherwise the calibration status cannot be entered. Before exit by pressing the button [enter],
the calibration switch should be closed after completion of calibration; otherwise the
auxiliary display will show the message [CALEnd]; It can be quitted by pressing [exit] and
To Next Page
Loading...
