1-12
Removing/Attaching the Digital Operator and
Front Cover
This section demonstrates how the digital operator and front cover are removed.
Remove the terminal cover and then use the following procedures to remove the digital operator and front
cover.
Removing the Digital Operator
Press the lever on the side of the digital operator in the direction of arrow 1 to unlock the digital operator and
lift the digital operator in the direction of arrow 2 to remove the digital operator as shown in the following
illustration.
Fig 1.10 Removing the Digital Operator (Model: CIMR-ACA4011)
Removing the Front Cover
Pull the bottom of the front cover in the direction as shown by arrow 2 while pushing both sides of the cover in
the direction shown by arrow 1.
Fig 1.11 Removing the Front Cover (Model: CIMR-ACA4011)
To Next Page
Loading...