vi
îš„ Other
• Do not attempt to modify or alter the MxC.
Failure to do so may result in injury or electric shock.
• Contact your Yaskawa representative if you intend to use the MxC with a non-Yaskawa motor or
any other motor not listed in Yaskawa product literature.
The MxC can be used with three-phase induction motors with 2, 4, or 6 poles. A multi-pole motor with 8 poles or more, a
PM motor, or a motor designed for use with machine tools cannot be used with the MxC.
• Install adequate branch circuit short circuit protection per applicable codes.
Failure to comply may result in damage to the MxC.
The MxC is suitable for circuits capable of delivering not more than 100,000 RMS symmetrical Amperes, 220 Vac maxi-
mum (200 V Class) and 480 Vac maximum (400 V Class).
• If disinfectants or insecticides must be used to treat packing materials such as wooden frames, pal-
lets, or plywood, the packing materials must be treated before the product is packaged, and meth-
ods other than fumigation must be used.
Example: Heat treatment, where materials are kiln-dried to a core temperature of 56
°C for 30
minutes or more.
If the electronic products, which include stand-alone products and products installed in machines, are packed with fumi-
gated wooden materials, the electrical components may be greatly damaged by the gases or fumes resulting from the fumi-
gation process. In particular, disinfectants containing halogen, which includes chlorine, fluorine, bromine, or iodine can
contribute to the erosion of the capacitors.
To Next Page
Loading...
Need help?
General
