To Next PageTo Next PageWhat does Er-09 error mean on YASKAWA CIMR-V 4A0023F?
Er-09 on a YASKAWA Controller indicates an acceleration error, meaning the motor did not accelerate for the specified acceleration time. To solve this: * Increase the acceleration time C1-01. * Check the torque limits L7-01 and L7-02.
How to resolve a 'Block' error on my YASKAWA Controller?
A 'Block' error on your YASKAWA Controller occurs when the software base block function is assigned to one of the digital inputs and the input is off, preventing the drive from accepting Run commands. To resolve this: * Check the digital inputs function selection. * Check the upper controller sequence.
How do I fix an Er-01 error on my YASKAWA Controller?
If your YASKAWA Controller displays an Er-01 error, it indicates a motor data fault where the input motor data is not valid (e.g., the base frequency and base speed do not fit). To resolve this, re-enter the data and repeat Auto-Tuning.
What does Er-02 error mean on YASKAWA Controller?
If your YASKAWA Controller displays an Er-02 error, it indicates a minor fault that could be due to faulty wiring or an excessively heavy load. To resolve this: * Check the wiring. * Check the load. Always perform Auto-Tuning with the load decoupled from the motor.
What does Braking Transistor Fault mean on YASKAWA Controller?
A Braking Transistor Fault on your YASKAWA Controller indicates that the internal braking transistor is broken. To resolve this: * Cycle the power supply. * Replace the drive if the fault reoccurs.
What does Er-04 error mean on YASKAWA CIMR-V 4A0023F Controller?
If your YASKAWA Controller displays an Er-04 error, it indicates a resistance fault due to wrong input data, auto tuning exceeding the given time frame, or calculated values being out of range. To resolve this: * Check the input data. * Check the wiring. * Re-enter the data and repeat the Auto-Tuning.
General| Model | CIMR-V 4A0023F |
|---|---|
| Output Current | 2.3 A |
| Frequency Range | 0-400 Hz |
| Control Method | vector control |
| Protection Features | Overcurrent, overvoltage, undervoltage, short circuit |
| Cooling Method | Fan |
| Operating Temperature | -10°C to +50°C |
| Humidity | 95% RH or less (non-condensing) |
| Altitude | 1000m or less |
| Vibration | 5.9 m/s² or less |
Essential safety instructions, warnings, and precautions for handling and operating the drive.
General overview of main and control circuit wiring diagrams and connections.
Step-by-step guide for initial drive setup, including power on and basic checks.
Selection of control mode, duty rating, and the process for auto-tuning motor data.
Common faults, alarms, causes, corrective actions, and operator programming errors.
Detailed list of specific drive faults and errors encountered during auto-tuning.
