2 Parameter/Monitor Modes
2.1.2 Parameter Classification
2-6
2.1.2 Parameter Classification
Parameters of the
Σ
-V Series SERVOPACK are classified into two types of parame-
ters. One type of parameters is required for setting up the basic conditions for opera-
tion and the other type is required for tuning parameters that are required to adjust
servomotor characteristics.
Classification Meaning Display Method Setting Method
Setup Parameters
Parameters required
for setup.
Always displayed
(Factory setting:
Pn00B.0 = 0)
Set each parameter
individually.
Tuning Parameters
Parameters for tun-
ing control gain and
other parameters.
Set Pn00B.0 to 1.
There is no need to
set each parameter
individually.
To Next Page
Loading...
Need help?
General
