YASKAWA FS100 - Update of Logging Information

3Operation
FS100 3.3 Update of Logging Information
3-6
HW1480758
HW1480758
3.3 Update of Logging Information
When the new log is added during the display of the logging information
window, pressing the {SELECT} key shows the confirmation dialog box
“The log was added. Update the display?”. If “Yes” is selected, the log
data is obtained again and the display is updated. If “No” is selected, the
display is not updated but the same dialog box is displayed again if the
{SELECT} key is pressed later.
When the type of the log is set to “operation” or “editing”, pressing the
{SELECT} key displays the above confirmation dialog box only if the same
type of log as that shown is added.
16/20