2 Logging Function
FS100 2.1 Data to be Logged
2-1
HW1480758
HW1480758
2 Logging Function
2.1 Data to be Logged
This function logs the following data.
• Operation system
• START, HOLD, E-STOP (The operation in remote mode is also
logged.)
• Change of mode (PLAY/TEACH/REMOTE) (The operation in
remote mode is also logged.)
• Safety fence OPEN
• Selection of job (including direct open)
• Calling of master jobs
• Initialization of files and jobs
• Load and save of files and jobs (normal termination/abnormal
termination) (Load and save operation by DCI function and data
transmission function are not recorded in the log.)
• New creation, delete, rename, parallel shift job conversion, mir-
ror shift conversion, and PAM (position modification during play-
back) of jobs
• Change of manipulator home position
• Login/logoff (only when the password protection function is used)
• Edit system
• Job: Addition of instructions
Change of conditions in instructions
Delete of instructions
CUT, PASTE, and REVERSE PASTE operations
UNDO and REDO operations
Edit of job header
• Edit of condition files/general data
• Edit of parameters
• Edit of CIO
Edit in the ladder program display
In the execution of compile, the previous edit history
(addition/change/delete of lines) is output together.
Because the recorded time is the time when each edit was
actually performed, it may not equal to the time of compile
• Edit of variables (Edit in remote mode is not recorded in the log.)
• Edit of I/O
The log of switch ON/OFF of general input/output signals is
obtained.
NOTE
Only the edit operations performed by the user are logged.
Variables or I/O status changed by the execution of instruc-
tions or others in the job are not recorded in the log.
To Next Page
Loading...
Need help?
General
