YASKAWA FS100 Operator's Manual

FS100
v
HW1480758
HW1480758
Definition of Terms Used Often in This Manual
The MOTOMAN is the YASKAWA industrial robot product.
The MOTOMAN usually consists of the manipulator, the FS100 controller,
manipulator cables, the FS100 programming pendant (optional), and the
FS100 programming pendant dummy connector (optional).
In this manual, the equipment is designated as follows:
WARNING
• Confirm that no person is present in the P-point maximum envelope
of the manipulator and that you are in a safe location before:
– Turning on the power for the FS100.
– Moving the manipulator with the programming pendant.
– Running the system in the check mode.
– Performing automatic operations.
Injury may result if anyone enters the working envelope of the
manipulator during operation. Always press an emergency stop button
immediately if there are problems.
CAUTION
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the FS100 after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the
FS100 Instructions before operating the manipulator:
Equipment Manual Designation
FS100 controller FS100
FS100 programming pendant Programming pendant
Cable between the manipulator
and the controller
Manipulator Cable
FS100 programming pendant
dummy connector
Programming pendant
dummy connector
5/20

YASKAWA FS100 Specifications

General

Brand	YASKAWA
Model	FS100
Category	Controller
Language	English